DETAILED INFORMATION

1.Material: high-impact engineering ABS or PP;
2.Operating Temperature: -40℃ to 98 ℃;
3.Better waterproof, shockproof and anti-corrosion performance;
4.Filled with pre-cut foam and easy to customize compartment for your valuable tool;
5.Having a knob with O-ring for manual pressure adjustment;
6.Draw latch snaps tightly closed, it won’t be broken even under higher impact;
7.Areas on the lid and back for sticking logos;
8.Widely used for hardware tools, medical equipments, precision instruments, laptop and etc.

1.There is area for sticking LOGO at both the bottom of case body and the top of cover.
2.The silicone rubber gasket is the key for the sealing and waterproof of the case, and at the time of

   clearing and washing the case opening, prevent scraping or scratching the gasket. Guard against

   pricking by needle or cutting by knife.
3.At the time of using, any foreign matter adhered to the gasket and the chimb of case opening, such

   as sand particle and scrap, etc., shall be examined and cleared to guarantee the absolute sealing

   of the case.
4.All Safety Equipment Cases are designed with purge value, which is right beside the handle. In case

   you are unable to open after flight, travel or returning from mountain elevations, you can open the case

   by simply loosening the value in anti-clockwise to balance the pressure inside and outside of the case.
5.Various stains adhered on the outer surface of the case can be washed by household abluent. Avoid

   the use of hard brush, such as steel wire brush, so as to prevent scratch on the surface.
6.With the multilayer foam cut into cubed pattern in advance, it is easier to customize various cavities. If

   too much foam block is moved out because of carelessness, it can be agglutinated by glue.
7:In the season with high temperature and high humidity, in order to avoid too high temperature in the case,

   do not put the equipment case to any place exposed to the scorching sun or where high heat is generated.

1.Color can be customized(need samples), but we have MOQ;
2.Material can be changed, such as adding flame retardant, antistatic agent;
3.Modifications can ben done, such as drilling holes, adding or changing PCB pillars(not free in charge);
4.All the products are designned under the regulations of certain protections, but we don’t provide

   the certificates;
5.For some special requirements, please contact us in advance and describe this in the PO;
6.Because of revising and updating, technic data may not be updated on time, please get the

   confirmation before order;
7.Welcome to DEVELOP NEW MOULD with us, including OEM!